Safe Z homing for Power Loss Recovery (#16909)
This commit is contained in:
@@ -1256,7 +1256,6 @@
|
||||
#if ENABLED(POWER_LOSS_RECOVERY)
|
||||
#define PLR_ENABLED_DEFAULT false // Power Loss Recovery enabled by default. (Set with 'M413 Sn' & M500)
|
||||
//#define BACKUP_POWER_SUPPLY // Backup power / UPS to move the steppers on power loss
|
||||
//#define POWER_LOSS_RECOVER_ZHOME // Z homing is needed for proper recovery. 99.9% of the time this should be disabled!
|
||||
//#define POWER_LOSS_ZRAISE 2 // (mm) Z axis raise on resume (on power loss with UPS)
|
||||
//#define POWER_LOSS_PIN 44 // Pin to detect power loss. Set to -1 to disable default pin on boards without module.
|
||||
//#define POWER_LOSS_STATE HIGH // State of pin indicating power loss
|
||||
@@ -1268,6 +1267,12 @@
|
||||
// Without a POWER_LOSS_PIN the following option helps reduce wear on the SD card,
|
||||
// especially with "vase mode" printing. Set too high and vases cannot be continued.
|
||||
#define POWER_LOSS_MIN_Z_CHANGE 0.05 // (mm) Minimum Z change before saving power-loss data
|
||||
|
||||
// Enable if Z homing is needed for proper recovery. 99.9% of the time this should be disabled!
|
||||
//#define POWER_LOSS_RECOVER_ZHOME
|
||||
#if ENABLED(POWER_LOSS_RECOVER_ZHOME)
|
||||
//#define POWER_LOSS_ZHOME_POS { 0, 0 } // Safe XY position to home Z while avoiding objects on the bed
|
||||
#endif
|
||||
#endif
|
||||
|
||||
/**
|
||||
|
Reference in New Issue
Block a user