Inital commit

sketch/sketch.ino

@@ -0,0 +1,96 @@
+#include <Chrono.h>
+#include <LightChrono.h>
+
+/*
+Need 3.3V supply to touch controls. Voltage feedback for each section
+#Whammy Bar. 3.3V supply to pot
+
+Inputs:
+D6 Strum Up
+D5 Strum Down
+D0 Green Button
+D1 Red Button
+D2 Yellow Button
+D3 Blue Button
+D4 Orange Button
+A1 Slider Bar
+Whammy Bar - Analog
+Start Select
+Up
+Down
+Left
+Right
+
+Outputs:
+LED's
+22
+23
+
+*/
+int ledState = LOW;
+Chrono ledTimer;
+
+void setup() {
+
+  Serial.begin(9600); // USB is always 12 Mbit/sec
+//  analogReadAveraging(8);
+  pinMode(0, INPUT_PULLUP);
+  pinMode(1, INPUT_PULLUP);
+  pinMode(2, INPUT_PULLUP);
+  pinMode(3, INPUT_PULLUP);
+  pinMode(4, INPUT_PULLUP);
+  pinMode(5, INPUT_PULLUP);
+  pinMode(6, INPUT_PULLUP);
+  pinMode(23, OUTPUT);
+  digitalWrite(23, ledState);
+  pinMode(22, OUTPUT);
+  digitalWrite(23, !ledState);
+
+}
+
+//int slider = 0;
+
+void loop() {
+
+//  slider = analogRead(1);
+  
+//  Serial.println(slider);
+//  delay(500);
+
+  if (digitalRead(0) == LOW ) {
+    Serial.println("Green");
+  }
+  
+  if (digitalRead(1) == LOW ) {
+    Serial.println("Red");
+  }
+
+  if (digitalRead(2) == LOW ) {
+    Serial.println("Yellow");
+  }
+
+  if (digitalRead(3) == LOW ) {
+    Serial.println("Blue");
+  }
+
+  if (digitalRead(4) == LOW ) {
+    Serial.println("Orange");
+  }
+
+  if (digitalRead(5) == LOW ) {
+    Serial.println("Strum Up");
+  }
+
+  if (digitalRead(6) == LOW ) {
+    Serial.println("Strum Down");
+  }
+
+  if(ledTimer.hasPassed(500)) {
+    ledTimer.restart();
+    digitalWrite(23, !ledState);
+    digitalWrite(22, ledState);
+    ledState = !ledState;
+  }
+
+//  delay(500);
+}