Marlin_Firmware/Marlin/src/pins/pins_MALYAN_M200.h
2019-02-12 15:30:11 -06:00

91 lines
2.6 KiB
C

/**
* Marlin 3D Printer Firmware
* Copyright (C) 2019 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
*
* Based on Sprinter and grbl.
* Copyright (C) 2011 Camiel Gubbels / Erik van der Zalm
*
* This program is free software: you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation, either version 3 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program. If not, see <http://www.gnu.org/licenses/>.
*
*/
/**
* MALYAN M200 pin assignments
*/
#ifndef __STM32F1__
#error "Oops! You must be compiling for STM32."
#endif
#define BOARD_NAME "MALYANM200"
// Enable EEPROM Emulation for this board
// This setting should probably be in configuration.h
// but it is literally the only board which uses it.
#define FLASH_EEPROM_EMULATION
#define SDSS SS_PIN
//
// Limit Switches
//
#define X_MIN_PIN PB4
#define Y_MIN_PIN PA15
#define Z_MIN_PIN PB5
//
// Steppers
//
// X & Y enable are the same
#define X_STEP_PIN PB14
#define X_DIR_PIN PB15
#define X_ENABLE_PIN PA8
#define Y_STEP_PIN PB12
#define Y_DIR_PIN PB13
#define Y_ENABLE_PIN PA8
#define Z_STEP_PIN PB10
#define Z_DIR_PIN PB2
#define Z_ENABLE_PIN PB11
#define E0_STEP_PIN PB0
#define E0_DIR_PIN PC13
#define E0_ENABLE_PIN PB1
//
// Temperature Sensors
//
#define TEMP_0_PIN PA0 // Analog Input (HOTEND0 thermistor)
#define TEMP_BED_PIN PA1 // Analog Input (BED thermistor)
//
// Heaters / Fans
//
#define HEATER_0_PIN PB6 // HOTEND0 MOSFET
#define HEATER_BED_PIN PB7 // BED MOSFET
// FAN_PIN is commented out here because the M200 example
// Configuration_adv.h does NOT override E0_AUTO_FAN_PIN.
#ifndef FAN_PIN
//#define FAN_PIN PB8 // FAN1 header on board - PRINT FAN
#endif
#define FAN1_PIN PB3 // FAN2 header on board - CONTROLLER FAN
#define FAN2_PIN -1 // FAN3 header on board - EXTRUDER0 FAN
// This board has only the controller fan and the extruder fan
// If someone hacks to put a direct power fan on the controller, PB3 could
// be used as a separate print cooling fan.
#define ORIG_E0_AUTO_FAN_PIN PB8