diff --git a/Marlin/src/MarlinCore.cpp b/Marlin/src/MarlinCore.cpp
index d05c9c6014..e4fbf31a27 100644
--- a/Marlin/src/MarlinCore.cpp
+++ b/Marlin/src/MarlinCore.cpp
@@ -875,6 +875,19 @@ void stop() {
  */
 void setup() {
 
+  #if ENABLED(MARLIN_DEV_MODE)
+    auto log_current_ms = [&](PGM_P const msg) {
+      SERIAL_ECHO_START();
+      SERIAL_CHAR('['); SERIAL_ECHO(millis()); SERIAL_ECHO("] ");
+      serialprintPGM(msg);
+      SERIAL_EOL();
+    };
+    #define SETUP_LOG(M) log_current_ms(PSTR(M))
+  #else
+    #define SETUP_LOG(...) NOOP
+  #endif
+  #define SETUP_RUN(C) do{ SETUP_LOG(STRINGIFY(C)); C; }while(0)
+
   HAL_init();
 
   #if HAS_L64XX
@@ -939,12 +952,13 @@ void setup() {
 
   #if HAS_TMC_SPI
     #if DISABLED(TMC_USE_SW_SPI)
-      SPI.begin();
+      SETUP_RUN(SPI.begin());
     #endif
-    tmc_init_cs_pins();
+    SETUP_RUN(tmc_init_cs_pins());
   #endif
 
   #ifdef BOARD_INIT
+    SETUP_LOG("BOARD_INIT");
     BOARD_INIT();
   #endif
 
@@ -977,19 +991,6 @@ void setup() {
   // UI must be initialized before EEPROM
   // (because EEPROM code calls the UI).
 
-  #if ENABLED(MARLIN_DEV_MODE)
-    auto log_current_ms = [&](PGM_P const msg) {
-      SERIAL_ECHO_START();
-      SERIAL_CHAR('['); SERIAL_ECHO(millis()); SERIAL_ECHO("] ");
-      serialprintPGM(msg);
-      SERIAL_EOL();
-    };
-    #define SETUP_LOG(M) log_current_ms(PSTR(M))
-  #else
-    #define SETUP_LOG(...) NOOP
-  #endif
-  #define SETUP_RUN(C) do{ SETUP_LOG(STRINGIFY(C)); C; }while(0)
-
   // Set up LEDs early
   #if HAS_COLOR_LEDS
     SETUP_RUN(leds.setup());