bissen21/Marlin_Firmware
1
0
Fork 0
Code Issues Pull Requests Projects Releases 4 Wiki Activity

Fix Anycubic Kossel config (probe crash) (#11832)

Browse Source
This commit is contained in:
Hannes Brandstätter-Müller
2018-09-16 06:27:21 +02:00
committed by Scott Lahteine
parent 66f83d33e6
commit bc06406d7d
3 changed files with 5 additions and 4 deletions
Download Patch File Download Diff File Expand all files Collapse all files

4
Marlin/src/config/examples/delta/Anycubic/Kossel/Configuration.h
View File

@@ -1017,8 +1017,8 @@
* But: `M851 Z+1` with a CLEARANCE of 2 => 2mm from bed to nozzle.
*/
#define Z_CLEARANCE_DEPLOY_PROBE 10 // Z Clearance for Deploy/Stow
#define Z_CLEARANCE_BETWEEN_PROBES 5 // Z Clearance between probe points
#define Z_CLEARANCE_MULTI_PROBE 5 // Z Clearance between multiple probes
#define Z_CLEARANCE_BETWEEN_PROBES 25 // Z Clearance between probe points
#define Z_CLEARANCE_MULTI_PROBE 25 // Z Clearance between multiple probes
#define Z_AFTER_PROBING 30 // Z position after probing is done
#define Z_PROBE_LOW_POINT -2 // Farthest distance below the trigger-point to go before stopping

2
Marlin/src/config/examples/delta/Anycubic/Kossel/Configuration_adv.h
View File

@@ -237,7 +237,7 @@
* Multiple extruders can be assigned to the same pin in which case
* the fan will turn on when any selected extruder is above the threshold.
*/
#define E0_AUTO_FAN_PIN ORIG_E0_AUTO_FAN_PIN
//#define E0_AUTO_FAN_PIN -1
#define E1_AUTO_FAN_PIN -1
#define E2_AUTO_FAN_PIN -1
#define E3_AUTO_FAN_PIN -1

3
Marlin/src/config/examples/delta/Anycubic/Kossel/README.md
View File

@@ -8,13 +8,14 @@ These configurations activate many of the new advanced features of the Marlin fi
**Important**: Before doing anything else after updating the firmware, go to `Configuration > Advanced Settings > Initialize EEPROM` to get rid of old configurations.
Then you should execute `Configuration > Delta Calibration > Set Delta Height` and also run `Configuration > Delta Configuration > Probe Z-offset` to verify the Probe offset.
After that you should connect the Z-Probe and start `Configuration > Delta Calibration > Auto Calibration`. When it's done don't forget to also do `Configuration > Delta Calibration > Store Settings` to make it permanent.
You should also do a `Motion > Bed Leveling > Level bed` followed by `Store Settings` to ensure a perfect leveling.
Please do a manual paper test (moving the nozzle slowly down to Z0 and checking with a piece of paper). If it's not perfect, use `Configuration > Advanced Settings > Probe Z Offset` to correct the difference and execute the calibration again.
**Also Important**: if you value your Z-Probe do NOT execute `Configuration > Delta Configuration > Probe Z-offset` - This can destroy the Z-Probe, see issue [#11337](https://github.com/MarlinFirmware/Marlin/issues/11337).
# Select the Configuration