Fix up Fysetc configs, pins. Fix menu type float5
. (#15157)
This commit is contained in:
committed by
Scott Lahteine
parent
293b890940
commit
8e044ea898
@ -641,9 +641,9 @@
|
||||
#endif
|
||||
|
||||
// Mechanical endstop with COM to ground and NC to Signal uses "false" here (most common setup).
|
||||
#define X_MIN_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
|
||||
#define Y_MIN_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
|
||||
#define Z_MIN_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
|
||||
#define X_MIN_ENDSTOP_INVERTING true // Set to true to invert the logic of the endstop.
|
||||
#define Y_MIN_ENDSTOP_INVERTING true // Set to true to invert the logic of the endstop.
|
||||
#define Z_MIN_ENDSTOP_INVERTING true // Set to true to invert the logic of the endstop.
|
||||
#define X_MAX_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
|
||||
#define Y_MAX_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
|
||||
#define Z_MAX_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
|
||||
@ -721,7 +721,7 @@
|
||||
* Override with M92
|
||||
* X, Y, Z, E0 [, E1[, E2[, E3[, E4[, E5]]]]]
|
||||
*/
|
||||
#define DEFAULT_AXIS_STEPS_PER_UNIT { 80, 80, 400, 93 }
|
||||
#define DEFAULT_AXIS_STEPS_PER_UNIT { 640, 640, 3200, 800 }
|
||||
|
||||
/**
|
||||
* Default Max Feed Rate (mm/s)
|
||||
@ -989,10 +989,10 @@
|
||||
|
||||
// For Inverting Stepper Enable Pins (Active Low) use 0, Non Inverting (Active High) use 1
|
||||
// :{ 0:'Low', 1:'High' }
|
||||
#define X_ENABLE_ON 0
|
||||
#define Y_ENABLE_ON 0
|
||||
#define Z_ENABLE_ON 0
|
||||
#define E_ENABLE_ON 0 // For all extruders
|
||||
#define X_ENABLE_ON 1
|
||||
#define Y_ENABLE_ON 1
|
||||
#define Z_ENABLE_ON 1
|
||||
#define E_ENABLE_ON 1 // For all extruders
|
||||
|
||||
// Disables axis stepper immediately when it's not being used.
|
||||
// WARNING: When motors turn off there is a chance of losing position accuracy!
|
||||
|
Reference in New Issue
Block a user