Bring configs up to date

Marlin/example_configurations/makibox/Configuration.h

@@ -161,7 +161,10 @@
 //#define SWITCHING_EXTRUDER
 #if ENABLED(SWITCHING_EXTRUDER)
   #define SWITCHING_EXTRUDER_SERVO_NR 0
-  #define SWITCHING_EXTRUDER_SERVO_ANGLES { 0, 90 } // Angles for E0, E1
+  #define SWITCHING_EXTRUDER_SERVO_ANGLES { 0, 90 } // Angles for E0, E1[, E2, E3]
+  #if EXTRUDERS > 3
+    #define SWITCHING_EXTRUDER_E23_SERVO_NR 1
+  #endif
 #endif
 
 // A dual-nozzle that uses a servomotor to raise/lower one of the nozzles
@@ -370,9 +373,9 @@
 // setting this to anything other than 255 enables a form of PWM to the bed just like HEATER_BED_DUTY_CYCLE_DIVIDER did,
 // so you shouldn't use it unless you are OK with PWM on your bed.  (see the comment on enabling PIDTEMPBED)
 #define MAX_BED_POWER 175 // limits duty cycle to bed; 255=full current
-// This limit is set to 175 by default in the Makibox configuration and it can adjusted
-// to increase the heat up rate. However, if changed, user must be aware of the safety concerns
-// of drawing too much current from the power supply.
+// This limit is set to 175 by default in the Makibox configuration and it can be adjusted
+// to increase the heatup rate. However, if changed, be aware of the safety concerns of
+// drawing too much current from the power supply.
 
 #if ENABLED(PIDTEMPBED)
 
@@ -1460,11 +1463,6 @@
 //
 //#define U8GLIB_SSD1306
 
-//
-// TinyBoy2 128x64 OLED / Encoder Panel
-//
-//#define OLED_PANEL_TINYBOY2
-
 //
 // SAV OLEd LCD module support using either SSD1306 or SH1106 based LCD modules
 //
@@ -1482,6 +1480,11 @@
 //
 //#define SAV_3DLCD
 
+//
+// TinyBoy2 128x64 OLED / Encoder Panel
+//
+//#define OLED_PANEL_TINYBOY2
+
 //=============================================================================
 //=============================== Extra Features ==============================
 //=============================================================================