bissen21/Marlin_Firmware
1
0
Fork 0
Code Issues Pull Requests Projects Releases 4 Wiki Activity

Optimize G-code flag parameters (#21849)

Browse Source
This commit is contained in:
Scott Lahteine
2021-05-09 03:50:51 -05:00
committed by Scott Lahteine
parent 770edea577
commit 6a1e78e614
25 changed files with 95 additions and 94 deletions
Download Patch File Download Diff File Expand all files Collapse all files

2
Marlin/src/gcode/feature/pause/M125.cpp
View File

@ -56,7 +56,7 @@
*/
void GcodeSuite::M125() {
// Initial retract before move to filament change position
const float retract = -ABS(parser.seen('L') ? parser.value_axis_units(E_AXIS) : (PAUSE_PARK_RETRACT_LENGTH));
const float retract = -ABS(parser.axisunitsval('L', E_AXIS, PAUSE_PARK_RETRACT_LENGTH));
xyz_pos_t park_point = NOZZLE_PARK_POINT;

14
Marlin/src/gcode/feature/pause/M600.cpp
View File

@ -81,8 +81,8 @@ void GcodeSuite::M600() {
#if ENABLED(DUAL_X_CARRIAGE)
int8_t DXC_ext = target_extruder;
if (!parser.seen('T')) { // If no tool index is specified, M600 was (probably) sent in response to filament runout.
// In this case, for duplicating modes set DXC_ext to the extruder that ran out.
if (!parser.seen_test('T')) { // If no tool index is specified, M600 was (probably) sent in response to filament runout.
// In this case, for duplicating modes set DXC_ext to the extruder that ran out.
#if MULTI_FILAMENT_SENSOR
if (idex_is_duplicating())
DXC_ext = (READ(FIL_RUNOUT2_PIN) == FIL_RUNOUT2_STATE) ? 1 : 0;
@ -110,7 +110,7 @@ void GcodeSuite::M600() {
#endif
// Initial retract before move to filament change position
const float retract = -ABS(parser.seen('E') ? parser.value_axis_units(E_AXIS) : (PAUSE_PARK_RETRACT_LENGTH));
const float retract = -ABS(parser.axisunitsval('E', E_AXIS, PAUSE_PARK_RETRACT_LENGTH));
xyz_pos_t park_point NOZZLE_PARK_POINT;
@ -132,15 +132,11 @@ void GcodeSuite::M600() {
fast_load_length = 0.0f;
#else
// Unload filament
const float unload_length = -ABS(parser.seen('U') ? parser.value_axis_units(E_AXIS)
: fc_settings[active_extruder].unload_length);
const float unload_length = -ABS(parser.axisunitsval('U', E_AXIS, fc_settings[active_extruder].unload_length));
// Slow load filament
constexpr float slow_load_length = FILAMENT_CHANGE_SLOW_LOAD_LENGTH;
// Fast load filament
const float fast_load_length = ABS(parser.seen('L') ? parser.value_axis_units(E_AXIS)
: fc_settings[active_extruder].load_length);
const float fast_load_length = ABS(parser.axisunitsval('L', E_AXIS, fc_settings[active_extruder].load_length));
#endif
const int beep_count = parser.intval('B', -1