Bring configs up to date

config/examples/Formbot/Raptor/Configuration.h

@@ -482,6 +482,7 @@
 #define HEATER_2_MINTEMP   5
 #define HEATER_3_MINTEMP   5
 #define HEATER_4_MINTEMP   5
+#define HEATER_5_MINTEMP   5
 #define BED_MINTEMP        5
 
 // Above this temperature the heater will be switched off.
@@ -492,6 +493,7 @@
 #define HEATER_2_MAXTEMP 275
 #define HEATER_3_MAXTEMP 275
 #define HEATER_4_MAXTEMP 275
+#define HEATER_5_MAXTEMP 275
 #if ENABLED(BED_AC)
   #define BED_MAXTEMP    150
 #else
@@ -1004,6 +1006,8 @@
  * Specify a Probe position as { X, Y, Z }
  */
 #define NOZZLE_TO_PROBE_OFFSET { -22, 0, -1.5 }
+
+// Certain types of probes need to stay away from edges
 #define MIN_PROBE_EDGE 10
 
 // X and Y axis travel speed (mm/m) between probes
@@ -1314,9 +1318,6 @@
   #define GRID_MAX_POINTS_X 6
   #define GRID_MAX_POINTS_Y GRID_MAX_POINTS_X
 
-  // The Z probe minimum outer margin (to validate G29 parameters).
-  #define MIN_PROBE_EDGE 10
-
   // Probe along the Y axis, advancing X after each column
   //#define PROBE_Y_FIRST
 

config/examples/Formbot/T_Rex_2+/Configuration_adv.h

@@ -909,7 +909,19 @@
 // Add an 'M73' G-code to set the current percentage
 #define LCD_SET_PROGRESS_MANUALLY
 
-#if HAS_PRINT_PROGRESS
+// Show the E position (filament used) during printing
+//#define LCD_SHOW_E_TOTAL
+
+#if HAS_GRAPHICAL_LCD && HAS_PRINT_PROGRESS
+  //#define PRINT_PROGRESS_SHOW_DECIMALS // Show progress with decimal digits
+  //#define SHOW_REMAINING_TIME          // Display estimated time to completion
+  #if ENABLED(SHOW_REMAINING_TIME)
+    //#define USE_M73_REMAINING_TIME     // Use remaining time from M73 command instead of estimation
+    //#define ROTATE_PROGRESS_DISPLAY    // Display (P)rogress, (E)lapsed, and (R)emaining time
+  #endif
+#endif
+
+#if HAS_CHARACTER_LCD && HAS_PRINT_PROGRESS
   //#define LCD_PROGRESS_BAR              // Show a progress bar on HD44780 LCDs for SD printing
   #if ENABLED(LCD_PROGRESS_BAR)
     #define PROGRESS_BAR_BAR_TIME 2000    // (ms) Amount of time to show the bar