Remove unnecessary tabs and spaces

Marlin/example_configurations/K8400/Dual-head/Configuration.h

@@ -206,7 +206,7 @@
 
 /**
  * --NORMAL IS 4.7kohm PULLUP!-- 1kohm pullup can be used on hotend sensor, using correct resistor and table
- * 
+ *
  * Temperature sensors available:
  *
  *    -3 : thermocouple with MAX31855 (only for sensor 0)
@@ -231,13 +231,13 @@
  *    60 : 100k Maker's Tool Works Kapton Bed Thermistor beta=3950
  *    66 : 4.7M High Temperature thermistor from Dyze Design
  *    70 : the 100K thermistor found in the bq Hephestos 2
- * 
+ *
  *       1k ohm pullup tables - This is atypical, and requires changing out the 4.7k pullup for 1k.
  *                              (but gives greater accuracy and more stable PID)
  *    51 : 100k thermistor - EPCOS (1k pullup)
  *    52 : 200k thermistor - ATC Semitec 204GT-2 (1k pullup)
  *    55 : 100k thermistor - ATC Semitec 104GT-2 (Used in ParCan & J-Head) (1k pullup)
- * 
+ *
  *  1047 : Pt1000 with 4k7 pullup
  *  1010 : Pt1000 with 1k pullup (non standard)
  *   147 : Pt100 with 4k7 pullup
@@ -827,10 +827,10 @@
     // The height can be set with M420 Z<height>
     #define ENABLE_LEVELING_FADE_HEIGHT
 
-    // 
+    //
     // Experimental Subdivision of the grid by Catmull-Rom method.
     // Synthesizes intermediate points to produce a more detailed mesh.
-    // 
+    //
     //#define ABL_BILINEAR_SUBDIVISION
     #if ENABLED(ABL_BILINEAR_SUBDIVISION)
       // Number of subdivisions between probe points