Marlin_Firmware/Marlin/pins_MEGATRONICS.h

84 lines
2.0 KiB
C
Raw Normal View History

/**
* MegaTronics pin assignments
*/
#ifndef __AVR_ATmega2560__
#error Oops! Make sure you have 'Arduino Mega' selected from the 'Tools -> Boards' menu.
#endif
#define LARGE_FLASH true
#define X_STEP_PIN 26
#define X_DIR_PIN 28
#define X_ENABLE_PIN 24
#define X_MIN_PIN 41
#define X_MAX_PIN 37
#define Y_STEP_PIN 60 // A6
#define Y_DIR_PIN 61 // A7
#define Y_ENABLE_PIN 22
#define Y_MIN_PIN 14
#define Y_MAX_PIN 15
#define Z_STEP_PIN 54 // A0
#define Z_DIR_PIN 55 // A1
#define Z_ENABLE_PIN 56 // A2
#define Z_MIN_PIN 18
#define Z_MAX_PIN 19
#define E0_STEP_PIN 31
#define E0_DIR_PIN 32
#define E0_ENABLE_PIN 38
#define E1_STEP_PIN 34
#define E1_DIR_PIN 36
#define E1_ENABLE_PIN 30
#define SDPOWER -1
#define SDSS 53
#define LED_PIN 13
2015-07-22 16:13:54 -05:00
#define FAN_PIN 7 // IO pin. Buffer needed
#define PS_ON_PIN 12
#define KILL_PIN -1
2015-07-22 16:13:54 -05:00
#define HEATER_0_PIN 9
#define HEATER_1_PIN 8
#define HEATER_2_PIN -1
#if TEMP_SENSOR_0 == -1
2015-07-22 16:13:54 -05:00
#define TEMP_0_PIN 8 // ANALOG NUMBERING
#else
2015-07-22 16:13:54 -05:00
#define TEMP_0_PIN 13 // ANALOG NUMBERING
#endif
#define TEMP_1_PIN 15 // ANALOG NUMBERING
#define TEMP_2_PIN -1 // ANALOG NUMBERING
#define HEATER_BED_PIN 10 // BED
#define TEMP_BED_PIN 14 // ANALOG NUMBERING
#define BEEPER_PIN 33 // AUX-4
#if defined(ULTRA_LCD) && defined(NEWPANEL)
2015-07-22 16:13:54 -05:00
#define LCD_PINS_RS 16
#define LCD_PINS_ENABLE 17
2015-07-22 16:13:54 -05:00
#define LCD_PINS_D4 23
#define LCD_PINS_D5 25
#define LCD_PINS_D6 27
#define LCD_PINS_D7 29
2015-07-22 16:13:54 -05:00
// Buttons directly attached using AUX-2
#define BTN_EN1 59
#define BTN_EN2 64
#define BTN_ENC 43
2015-07-22 16:13:54 -05:00
#define BLEN_C 2
#define BLEN_B 1
#define BLEN_A 0
#define SD_DETECT_PIN -1 // RAMPS doesn't use this
#endif // ULTRA_LCD && NEWPANEL